Network Camera Settings
3WEP ENCIPHERMENT
This is a security function that encrypts the data being transmitted so that it cannot be intercepted by an unauthorized third party.
The default setting is “DISABLE”. To enable encryption, select the number of bits for the encryption key to use from the
Available settings:
•WEP40: The encryption key can consist of up to 5 alphanumeric characters.
•WEP128: The encryption key can consist of up to 13 alphanumeric characters.
4ENCRYPTION KEY
Up to four types of encryption key can be set. The encryption settings are as follows. For example, if “WEP40” is selected from the [WEP ENCIPHERMENT
If “WEP128” is selected, select an encryption key of 13 characters.
•WEP40: The encryption key can consist of up to 5 alphanumeric characters.
•WEP128: The encryption key can consist of up to 13 alphanumeric characters.
The same encryption key should be set for the access point and for the camera.
(1)Type in the same character string for the key number.
(2)Select the same key number.
Note:
•These options cannot be selected if there is no encryption key in the ENCRYPTION KEY boxes.
•The settings for ESS ID and ENCRYPTION KEY (when encryption is enabled) are verified between the STA (camera) and the HP (access point).
5Ask the network administrator for the settings below, and type them in the appropriate boxes.
•IP ADDRESS
•SUBNET MASK
•GATEWAY ADDRESS
5 Once the settings have been completed, click the [SET] button, turn the power off, and then turn it back on again. This causes the settings to be accepted.
English | – 21 – |
