Network Camera Settings
1AUTHENTICATION
This sets the verification protocol to be use when connecting to the access point. Set this to the protocol specified by the Internet Service Provider. It should normally be set to “AUTO”.
Available settings:
•AUTO: PAP or CHAP is chosen automatically as required
•PAP: Only PAP verification is used.
•CHAP: Only CHAP verification is used.
2CIRCUIT TYPE
This sets the type of telephone circuit that the modem is connecting to.
Available settings:
•TONE: For tone dialing circuits
•PULSE: For pulse dialing circuits
Note: Set to “TONE” if using a terminal adapter.
3BAUD RATE
This sets the communication speed for the modem.
Available settings: 115200, 38400 (bps)
4DATA SIZE
Available settings: 8, 7 (bits)
5PARITY
This sets the parity.
Available settings:
•NONE: No parity
•EVEN: Even parity
•ODD: Odd parity
6STOP BIT
Available settings: 1, 1.5, 2
7AUTO IP ADDRESS display
This shows the IP address for the camera.
Note: This is only displayed while the camera is connected.
8ERROR INFO. display
This shows error information relating to the previous PPP connection.
Display details:
•Modem timeout or Not connected
•Line connection error
•Line disconnected
•PPP connection error
•PPP verification error
•PPP connected and disconnected normally
English | – 23 – |
