Sanyo vcc-zm300p instruction manual White balance additional settings AWC setting

VIEW SETTING

White balance additional settings 3

AWC setting

1	VIEW SETTING	1	2	AWC SETTING
	IRIS	AUTO	‚	AWC LOCK	SET
	WHITE BALANCE	AWC	‚
	SHUTTER	LONG	‚	GO TO MWB	SET ‚
	MOTION	OFF	‚
	APERTURE	ON	‚
	AGC	ON	‚
	GAMMA	ON

3AWC SETTING

AWC LOCK	SET
GO TO MWB	SET	‚

4MWB SETTING (OFFSET)

R	í---	ú--	+------	ü	70
B	í---	ú--	+------	ü	66

English

1Use the cursor button (j or l) to move the cursor to

AWC for WHITE BALANCE and press the SET button. The AWC SETTING screen will appear.

2With SET blinking for AWC LOCK, press the SET button. SET will light and adjustment of white balance will begin. After about 3 seconds, SET will begin blinking again, signaling that adjustment is complete.

Note:

For even finer adjustment of coloration, choose SET for GO TO MWB. White balance mode will become MWB for fine adjustment. After fine adjustment with GO TO MWB, the white balance mode will automatically switch to MWB.

Note: Full adjustment may not be possible with just one activation of SET for AWC LOCK. In that case, press the SET button again.

3GO TO MWB setting

Use the cursor button (j or l) to move the cursor to

SET for GO TO MWB and press the SET button.

The MWB SETTING screen will appear and the “R” value will be blinking.

4Use the cursor button (d or c) to adjust the value for “R” (red).

Available settings: 0 – 255

Note: The larger the number, the stronger red becomes.

5Use the cursor button (j or l) to move the cursor to “B”, then use the cursor button (d or c) to adjust the “Blue” value.

Available settings: 0 – 255

Note: The larger the number, the stronger blue becomes.

☞To close the menu screen or return to the previous screen, select BACK or END for MENU and press the SET button.

34