PARTS NAMES AND FUNCTIONS
Control
terminals3
SET
4
4Menu setting button (SET) (See p8)
Connect the camera to the monitor, then press the SET button for about 3 seconds to display the
5RS-485 control push-lock terminals (RS485, A, B, G)
Use a cable thicker than AWG22.
2
1
ZOOM | COM IN |
FOCUS | ALARM OUT |
VIDEO OUT
POWER
AC24V
RS485
5
A B G
GND
A: | G: Ground terminal |
B: |
|
6
DC12V |
|
|
|
| CLASS 2 WIRING |
|
|
|
|
|
|
1 Video output connector (VIDEO OUT: BNC type)
Connect this connector to a device such as a time lapse VCR or monitor with a VIDEO IN connector.
2Power indicator (POWER)
Comes on when the power to the camera is on.
Note: After connecting the power supply the POWER indicator will blink for 5 seconds. During this time no adjustments using the menus or any other operation are possible.
3 Cursor button (See p8)
j: Press this button to move the cursor up.
c: Press this button to move the cursor to the right, or to turn the settings ON/OFF etc.
d: Press this button to move the cursor to the left, or to turn the settings ON/OFF etc.
l: Press this button to move the cursor down.
6 24 V AC or 12 V DC input terminals (AC 24 V, DC 12 V, |
GND) |
Lens cap
The cap is installed to protect the lens section. Remove the cap when using the camera.
English
4
