If no directory name is specified, the system will automatically generate the following directory name.
When sending an alarm image in the event of an error: ALARM_FTP
When sending an image in fixed intervals: INTERVAL_FTP
6 
In [FILE NAME], specify the name of the image file you want to send and click 
SET 
.
You can type up to 32 alphanumeric characters.
Each image file will have a file name consisting of the specified file name, the date/time, and the alarm factor (if [TRIGGER] is set to other than “INTERVAL”):
[FILE NAME] + [yy_mm_dd_hh_mm_ss] + [alarm_factor] + [0001 (Serial No.).jpg]
If no file name is specified, the system will enter “sanyo” for the [FILE NAME].
* To use a temporary file, set [TEMPORARY FILE] to “USE”.
This causes each image to be stored as a temporary file on the FTP server and then renamed to the specified file name.
The FTP server will store a single temporary file for the most recent image with the specified file name.
Temporary file name: sanyo_ftp_temp_[IP address].temp
Although the temporary file will be renamed to the specified file name and then stored in the specified directory as explained in steps 5 
to 6 
, the renamed file name will not include the date/time and alarm factor information.
Both the temporary and permanent files will be overwritten if the same file name exists.
In [TRIGGER], select the image transmission trigger condition, configure items as necessary and click 
SET 
.
INTERVAL: Sends a still image in fixed intervals.
ALARM IN1: Sends a still image when the ALARM IN1 terminal receives an alarm signal.
ALARM IN2: Sends a still image when the ALARM IN2 terminal receives an alarm signal.
MOTION: Sends a still image when the motion sensor detects motion in the subject.
ALARM OUT1: Sends a still image when the ALARM OUT 1 terminal outputs an alarm signal.
ALARM OUT2: Sends a still image when the ALARM OUT 2 terminal outputs an alarm signal.
NETWORK FAILURE: Sends a still image when the camera detects a network failure during network recording.
You need to configure the alarm input/output conditions on the ALARM SETTINGS screen.
A If you selected “NETWORK FAILURE” ...
In [NETWORK FAILURE TIME], select the time from the occurrence of a network failure until the camera recognizes it as a recording trigger.
15SEC, 20SEC, 30SEC, 40SEC, 50SEC, 1MIN, 2MIN, 3MIN, 4MIN, 5MIN
