Sharp 4500 Sending An Image, Basic Transmission Method, Make sure the machine is in scanner mode

SENDING AN IMAGE

BASIC TRANSMISSION METHOD

1 Make sure the machine is in scanner mode.

5 If needed, adjust the exposure setting. (Refer to page 15.)

When the IMAGE SEND

key light is on, the machine	AUTO
	EXPOSURE
is in scanner mode. If the
light is not on, press the	STANDARD
IMAGE SEND key.	RESOLUTION

AUTO 81/2X11

ORIGINAL

The initial factory setting is AUTO.

2 Load the original.

For detailed information on loading an original, refer to pages 7 and 8 of "Operation manual (for copier)".

NOTE

You cannot load documents in both the auto document feeder and on the document glass and send them in a single transmission. If documents are loaded in both the auto document feeder and on the document glass, only the document in the auto document feeder will be scanned and transmitted.

6 Touch the SENDER LIST key.

		DIRECTORY	This step is not necessary
			for Scan to FTP or Scan to
			Desktop. Go directly to step
			9 (next page).
	ADDRESS REVIEW
-MAIL ADDRESS		SENDER LIST

NOTES

•You can omit selection of a sender (go directly to step 11). In this case, the default sender information stored with the key operator program is automatically transmitted. (Page 27)

•Up to 20 senders can be stored using the Web page. (Page 5)

3 Check the original size.

STANDARD

RESOLUTION

AUTO 81/2 X11

ORIGINAL

The original size is automatically detected.

If you loaded a non-standard size document or wish to change the scanning size, touch the ORIGINAL key and set the document size. (Refer to page 13.)

7 Touch a key to select a sender.

The touched key is

DER LIST

highlighted. If you made a

SHARP PPD	1 GROUP
	mistake, touch the correct
2 GROUP	key. The highlighting will
	move to the new key.
	The selected sender will be
	the sender of the e-mail.

NOTE

To scan a two-sided original or use the verification stamp function (if the optional verification stamp unit is installed), refer to pages 11 and 12.

4 If needed, adjust the resolution setting. (Refer to page 14.)

The initial factory setting is

STANDARDSTANDARD.

RESOLUTION

AUTO 81/2 X11

ORIGINAL

8 Touch the OK key.

1 GROUP

8