Sharp 450M Touch the ADDRESS DIRECTORY key, 10Touch the one-touch key for the desired destination

9 Touch the ADDRESS DIRECTORY key.

The address directory screen appears.

ADDRESS

DIRECTORY

10Touch the one-touch key for the desired destination.

		READY TO SEND.						Refer to page 7 for
								information on using the
	SHARP CORPORATION				T.P.S.			address directory screen.
	SHARP GROUP							The key you touched is
								highlighted. If you touch the
								wrong key, touch the key again
FREQUENT USE			ABCD	EFGHI		JKLMN	OPQRS	to cancel the selection.The key

display will return to normal.

SENDING AN IMAGE

Using the document glass

11Press the START key.

The original is scanned and the READ-END key appears.

12If you have another page to scan, change pages and then press the START key.

Repeat this sequence until all pages have been scanned. You can change the resolution and exposure settings as needed for each page (refer to pages 14 and 15).

If no action is taken for one minute, scanning automatically ends and the transmission job is stored.

NOTES

• Refer to pages 4 and 5 for information on programming

13After the final page is scanned, touch the READ- END key.

one-touch key destinations.

• You can also manually enter the address of a Scan to E-

mail destination, or select multiple destinations for a

broadcast transmission. (Next page)

Using the auto document feeder

11Press the START key.

Scanning begins and the transmission job is stored. (The job is transmitted after previously stored transmission jobs have been completed.)

If scanning is completed normally, the machine makes a beep sound to inform you that the transmission job is stored and JOB STORED appears in the message display.

L.(Pg.No. 3)

ESS [READ-END].

READ-END

Open the document document.

The machine makes a beep sound to inform you that the transmission job is stored and JOB STORED appears in the message display. (The destination is automatically called and the document transmitted after previously stored jobs are completed.)

glass cover and remove the

NOTES

•Canceling transmission

To cancel transmission while SCANNING ORIGINAL... appears in the display or before the READ-END key is pressed, press the C key or the CA key. To cancel a transmission job that is already stored, press the JOB STATUS key and cancel the job as explained on page 16.

•Important points when using Scan to E-mail

Be very careful not to send image data files that are too large.Your mail server's system administrator may have placed a limit on the amount of data that can be sent in one e-mail transmission. If this limit is exceeded, the e-mail will not be delivered to the recipient. Even if there is no limit and your e-mail is successfully delivered, a large data file may take a long time to be received and place a heavy burden on the recipient's network, depending on the recipient's network (Internet) connection environment. If large image data files are repeatedly sent, the resulting burden on the network may slow down the speed of other, unrelated data transmissions and in some cases, may even cause the mail server or network to go down.

In cases where you need to send multiple documents, try such measures as lowering the resolution or image quality mode.

•If the power is turned off or a power failure occurs while a document is being scanned in the auto document feeder, the machine will stop and a document misfeed will occur. After power is restored, remove the document as explained on page 29 of "Operation manual (for copier)".

9