Sharp AR-M200 operation manual Important points when selecting an installation site, 20 cm, 10 cm

CAUTIONS

Caution label on the machine

The label ( ) in the fusing area of the machine indicates the following:

: Caution, risk of danger : Caution, hot surface

Cautions on using the machine

Follow the cautions below when using this machine.

Warning:

•The fusing area is hot. Exercise care in this area when removing misfed paper.

•Do not look directly at the light source. Doing so may damage your eyes.

•Machine power must be turned off before installing any supplies.

Caution:

•Place the machine on a firm, level surface.

•Do not install the machine in a humid or dusty location.

•When the machine is not used for a long time, for example for consecutive holidays, turn the power switch off and remove the power cord from the outlet.

•When moving the machine, be sure to turn the power switch off and remove the power cord from the outlet.

•Do not switch the machine rapidly on and off. After turning the machine off, wait 10 to 15 seconds before turning it back on.

•Do not cover the machine with a dust cover, cloth or plastic film while the power is on. Doing so may prevent heat radiation, damaging the machine.

•Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.

•The socket-outlet shall be installed near the machine and shall be easily accessible.

Important points when selecting an installation site

Do not install your machine in areas that are:

•damp, humid, or very dusty

•exposed to direct sunlight

•poorly ventilated

•subject to extreme temperature or humidity changes, e.g., near an air conditioner or heater.

Be sure to allow the required space around the		20 cm
machine for servicing and proper ventilation.
	10 cm

10 cm

3