Sharp AR-M200 operation manual Troubleshooting and Maintenance, Display Messages

9

Chapter 9

TROUBLESHOOTING AND MAINTENANCE

Problems related to general use of the machine, the copy function, and software setup are explained here. Be sure to check the problem carefully before calling for service, as many problems can be solved by the user.

If you are unable to solve the problem, turn off the main switch, unplug the power cord from the outlet, and contact your dealer.

Note	For problems related to the printer and scanner functions, see the
	online manual.

DISPLAY MESSAGES

When the following indicators light up or blink on the operation panel or the following alphanumeric codes appear in the display, solve the problem immediately referring to both the table below and the indicated page.

Note Be sure to use only genuine SHARP parts and supplies.

	Indication		Cause and remedy	Page
Lamp indicator		Display
		BYPASS : ADD
Tray		PAPER	The indicated paper tray is not
	Blinks	TRAY<*> : ADD	attached, is attached incorrectly, or has	15
location
		PAPER	run out of paper. (The tray is indicated
indicator
			in <*>.)
		CLOSE PAPER
		TRAY<*>
		CLEAR PAPER	A paper misfeed has occurred.	76
		JAM.	Remove the misfeed as explained in
		SPF/RSPF JAM.	"MISFEED REMOVAL".
		FRONT OR SIDE	The cover is open. Close the cover.	-
		COVER OPEN.
		CLOSE COVERS.
		CLOSE THE SPF/	The document feeder cover is open. Close	-
		RSPF COVER.	the document feeder cover.
		REPLACE THE	The toner cartridge is empty. Replace
			the toner cartridge with a new	80
		TONER
			cartridge. (When the indicator blinks,
		CARTRIDGE.
Error indicator			the machine does not operate.)
			When [L1-00] appears, the scan head
Blinks
			locking switch is locked. Turn off the	82
			power, release the scan head locking
			switch, and turn the power back on.
			When [F2-02] appears, check the toner
				-	9
		SYSTEM ERROR	cartridge and make sure that the seal
			is not still affixed.
		[XX - XX] REFER
		TO USER GUIDE	The machine will not function. Turn the
			power switch off, wait about 10
			seconds, and then turn on the switch	-
			again. If this does not clear the error,
			remove the power cord from the outlet,
			and contact your authorised service
			representative.

67