Sharp AR-M200 Install a NEW, Cartridge is, Near Empty, Maintenance, Required Call, Resume, Cable

TROUBLESHOOTING AND MAINTENANCE

	Indication		Cause and remedy	Page
Lamp indicator		Display
		INSTALL A NEW	The toner cartridge is not installed
	Blinks	TONER		80
			correctly. Reinstall the toner cartridge.
		CARTRIDGE
Error		TONER	Replacement of toner cartridge will be
		CARTRIDGE IS		80
indicator			needed soon. Prepare a new cartridge.
	Steadily	NEAR EMPTY.
	lit
		MAINTENANCE	Service by an authorized SHARP
		REQUIRED CALL		-
			service technician is required.
		FOR SERVICE
MEMORY	FULL, PRESS START TO		Data is being held in memory. Print the	30
RESUME.			data or clear it from memory.
NO 2-SIDED COPY FROM BYPASS			Two sided printing or 2 IN 1 copying is
TRAY.			selected when the bypass tray is
			already selected ,or the bypass tray is	26
			selected when two-sided printing or 2
NO 2IN1 COPY FROM			IN 1 copying is already selected.	31
BYPASS TRAY.			The bypass tray cannot be used. Press
			the [TRAY SELECT] key ( ) to select
			a paper tray.
			2 IN 1 copy and margin shift cannot be	31
NO 2IN1 COPY WITH MARGIN SHIFT.			used in combination. Cancel the
				34
			function what was selected last.
COPY RATIO CAN NOT BE			Copy ratio can not be changed in 2 IN 1	25
CHANGED IN 2IN1.			copy.	31
THIS MENU IS NOT SELECTABLE			This appears if you attempt to change
			a user program setting while a copy or	54
WITH DATA.
			print job is in progress.
			There is no paper for printing. Press
NO XXXX SIZE TRAY			the [MODE SELECT] key to switch to
			printer mode and follow the instructions	-
			in the display.
			("XXXX" indicates paper size)
			An original remains on the document
			glass, or the original is too thick to	21
			scan. Remove the original.
CHECK SPF/RSPF.			If the message is no cleared when
			there is not original on the document
START TO RESUME.
			glass, the underside of the RSPF is	84
			dirty. Clean the underside of the RSPF.
			(especially areas where black lines
			appear.)
			Printing is not possible if the paper size
			setting is different from the size of
			paper loaded in the tray. Load the
LOAD XXXX PAPER INTO TRAY<*>.			same size of paper as the paper size	15
			setting and then press the [START] key
			( ). Printing will begin.
			("XXXX" indicates paper size. The tray
			is indicated in <*>.)
NO PC COMMUNICATION; CHECK			The machine is not correctly connected
			to the computer. Check the cable	42
CABLE.
			(when using the scanner function).

68