Sharp AR-M200 operation manual Power off, Power save modes, Preheat mode, Auto power shut-off mode

PREPARATIONS

Power off

Make sure that the machine is not in operation and then turn the power switch to the "OFF" position.

If the power switch is turned off while the machine is in operation, a misfeed may occur and the job that was in progress will be cancelled.

In cases where the machine will not be used for a 1 long time, turn off the power switch and remove the

power cord from the outlet.

Check the following to make sure the machine is not in operation:

•The ready indicator is lit. (Initial state)

•The power save indicator is lit. (preheat mode or auto power shut-off mode)

Power save modes

Preheat mode

This function automatically switches the machine to a low power consumption state if the set duration of time elapses without the machine being used when the power is on. In this mode, the power save indicator lights up. Normal operation automatically resumes when a key on the operation panel is pressed, an original is placed, a print job is received.

Auto power shut-off mode

This function automatically switches the machine to a state that consumes even less power than preheat mode if the set duration of time elapses without the machine being used when the power is on. The power save indicator lights up, the display shows a message indicating that the machine is in auto power shut-off mode. To resume normal

operation, press the [START] key ( ). Normal operation also resumes automatically when a print job is received or scanning is begun from a computer. While in auto power

shut-off mode, no keys (except the [START] key ( )) can be used.

The preheat activation time and the auto power shut-off time can be Note changed with "PREHEAT MODE" and "AUTO SHUT-OFF TIME" in the

user programs. It is suggested that you set times that are appropriate for your usage of the machine. (p.54, p.55)

Check original cover/RSPF open function

When enabled, this function may help prevent wasteful use of toner that occurs when the original cover/RSPF cover is not completely closed.

If the start ( ) key is pressed when the original cover/RSPF cover is not completely closed, "CHECK ORIGINAL" will appear in the display and copying may not take place. If copying does not take place, copying can be performed by pressing

the start ( ) key again, however, the scan size set in "CHANGING A TRAY'S PAPER SIZE SETTING" (p.19) or "VALID COPY WIDTH" (program number 25) (p.57) will be used.

If the original cover/RSPF cover is completely closed after "CHECK ORIGINAL" appears, copying will take place at the normal size.

13