Sharp AX-1100 Drain Water Function, Descale Function, P R O C E D U R E, Important Instructions

IMPORTANT INSTRUCTIONS

Drain Water Function

Perform the Drain Water function at least once a day after cooking with steam. It takes up to 7 minutes.

Drain Water function is very useful to prevent scale build up and the use of stale water. It causes evaporation of the internal steam system.

2 Press INFO/KITCHEN TIMER

twice to select “In F2”.

x 2

3 Place the glass tray in lower position (position 2) closely to attach to the back side of the oven wall.

ENGLISH

P R O C E D U R E

1	Remove the water tank. Ensure
	that no food is in the oven.
	Press INFO/KITCHEN TIMER
		x 1
	once to select “In F1”.
2	Press START /+1min.
	“In F1” will fl ash on and off in
	the display during the Drain
	Water function.	x 1

3 When the drain function has ended and the oven is cool, wipe oven cavity.

Empty the drip tray.

NOTES:

1.The water tank must be removed before starting this procedure.

2.If Drain Water Function is set, Energy Save Mode will be cancelled temporary.

Descale Function

White or gray grains, also called scale, may form in the water circuit inside the oven during steam generation, which could cause the oven to malfunction.

When "DESCALE (flashing)" is shown in the display, be sure to carry out Descale function immediately. It takes about 1 hour. (The descaling using citric acid or lemon juice is for about 30 minutes, and then rinsing with fresh water is for about 30 minutes.)

4 Do not place any food in the
	oven. Close the door fi rmly.
	Press START	/+1min to begin
	descaling. (about 30 min.)		x 1
5	When the oven has stopped and is cool, remove
	water tank, empty, rinse and refi ll with room
	temperature water suitable for drinking (fi ltered)
	to the MAX mark. Replace the water tank.
	Empty the drip tray and replace it.
	Remove glass tray, empty, rinse
	and dry. Follow step 3 to replace
	glass tray. Close the door firmly.
	Press START	/+1min.
			x 1
	Rinsing will start. (about 30 min.)

6 When rinsing has ended and the oven is cool, remove water tank and empty. Remove glass tray and empty. Wipe oven cavity to dry. Empty the drip tray.

NOTE:

If Descale Function is set, Energy Save Mode will be cancelled temporary.

P R O C E D U R E

1 Pure citric acid, available at some drugstores, or bottled 100% lemon juice with no pulp are used for descaling. Choose one and prepare the descaling solution.

To use pure citric acid, dissolve 1 tablespoon of pure citric acid crystals in 500ml of water in a non-porous container. Stir well and pour into the water tank to the MAX mark.

To use 100% bottled lemon juice, check that there is absolutely no pulp in it. If there is pulp or you are not sure, strain through a fi ne strainer. Measure 70ml of the strained lemon juice and add it to 500ml of water. Stir well and pour into the water tank to the MAX mark. Place the water tank in the oven correctly and push fi rmly into place.

EN – 9

AX1100_eng.indd 9

10.11.19 0:51:13 PM