Sharp AX-1100 Before Operating, Clean The Oven Before First Use, Getting Started, Stop/Clear

Models: AX-1100

1 60
Download 60 pages 44.83 Kb
Page 12
Image 12
BEFORE OPERATING

BEFORE OPERATING

Before operating your oven, make sure you read and understand this operation manual completely.

Before the oven can be used, follow these procedures:

1.Place the drip tray correctly. See page EN-7.

2.See below for getting started.

3.Follow directions on the right side for clean the oven before fi rst use.

Getting Started

Your oven has an Energy Save Mode. This facility saves electricity when the oven is not in use.

P R O C E D U R E

1 Plug the oven into a power point.

Nothing will appear on the display at this time.

2 Open the door. The display will show ".0".

3 Close the door.

Now you can ready to use the oven.

CAUTION:

In Energy Save Mode, if you do not operate the oven for 3 minutes or more (i.e. after closing the door, or pressing STOP/CLEAR, or at the end of cooking), you will not be able to operate the oven until you open and close the oven door.

NOTE:

When you set Child Lock or Demonstration Mode, Energy Save Mode will be cancelled temporary.

STOP/CLEAR

1.Press STOP/CLEAR if you make a mistake during programming.

2.Stop the oven temporarily during cooking.

3.Cancel a programme during cooking, press twice.

CLEAN THE OVEN BEFORE FIRST USE

You may detect smoke or a burning smell when using the grill for the first time, this is normal and not a sign that the oven is out of order. To avoid this problem, when first using the oven, operate the grill without food for 20 minutes.

PREPARATION

Ventilate the room.

P R O C E D U R E

1 Ensure that no food is in the oven. Enter the time by pressing TIME (20.00).

x 2

2 Press GRILL and

START /+1min.

x 1

x 1

WARNING:

The oven door, outer cabinet, oven cavity and especially the grill heating element will become hot.

EN – 10

AX1100_eng.indd 10

10.11.12 2:07:38 PM

Page 12
Image 12
Sharp AX-1100 Before Operating, Clean The Oven Before First Use, Getting Started, Stop/Clear, P R O C E D U R E