Sharp FODC550 operation manual Misfeed in the Rspf, Document feeder cover

TROUBLESHOOTING AND MAINTENANCE

4 Raise the fusing unit release lever, close the front cover and then close the side cover by pressing the round projections near the side cover open button. The error indicator will go out and the ready indicator will light up.

Caution

When closing the covers, be sure to close the front cover securely and then close the side cover. If the covers are closed in the wrong order, the covers may be damaged.

D: Misfeed in the RSPF

An original misfeed may occur at one of three locations: if the misfed original is visible in the document feeder tray, (A) in the document feeder tray; if the misfed original is not visible in the document feeder tray, (B) in the exit area or (C) under the document feeder cover. Remove the misfed original following the instructions for each location.

(A)Open the document feeder cover and pull the original gently to the left and out from the document feeder tray. Close the document feeder cover. Open and close the RSPF to clear the error indicator. If the misfed original cannot be easily removed, proceed to (C).

Document feeder cover

(B)Open the RSPF and rotate the roller to remove the misfed original from the exit area. If the misfed original cannot be easily removed, proceed to (C).

Roller

If the original is a two-sided original, pull out the reversing tray to remove the misfed original.

Reversing tray

Note	After removing a misfed original from the exit area of the RSPF, be sure
	to insert the reversing tray into the exit area until it locks in place.

82