Using a PC

Control of the TV

The TV can be controlled from a PC, control panels and other devices using the RS-232C or IP. Use a cross-type RS-232C cable, ETHERNET cable (commercially available) or wireless LAN for the connections.

NOTE

This operation system should be used by a person who is accustomed to using computers.

AQUOS Remote Control

Set this function when operating the TV from equipment connected by LAN or wireless LAN. To perform the operation, refer to "Smart TV".

Remote Control App

When "Remote Control App" is selected, "Change" will be highlighted. Press ENTER.

Detailed Settings

Make the detailed settings (Login ID, password, etc.).

Follow the on-screen instructions to configure the settings.

TV Name Setting

Set the name of the TV displayed on other network devices.

Use the software keyboard to set the name.

See page 9-5 for details on the software keyboard.

Communication Conditions for IP

Connect to the TV with the following settings made for IP on the PC.

IP protocol:

TCP/IP

 

 

Host IP address:

Set the IP address on the TV menu

 

 

Service:

None (Do not select Telnet or SSH)

 

 

TCP port#:

Set a port number on the TV menu (Control

 

port)

When you set your ID and password on the TV menu, you need to enter them as soon as you connect to the TV.

NOTE

When you use this function, make settings for "AQUOS Remote Control".

The connection will be cut off when there has been no communication for 3 minutes.

Communication Conditions for RS-232C

Set the RS-232C communication settings on the PC to match the TV's communication conditions. The TV's communication settings are as follows:

Baud rate:

9,600 bps

 

 

 

Data length:

8

bits

 

 

Parity bit:

None

 

 

 

Stop bit:

1

bit

 

 

Flow control:

None

 

 

 

Communication procedure

Send the control commands from the PC via the RS-232C or IP.

The TV operates according to the received command and sends a response message to the PC. Do not send multiple commands at the same time.

Wait until the PC receives the OK response before sending the next command.

ENG 8-3

Page 101
Image 101
Sharp LC60EQ10U manual Control of the TV