Sharp LC60EQ10U manual Configuring the TV Setting to Enhance 3D Image Viewing, 3D Brightness Boost

Enjoying 3D Image Viewing (For the UQ17U, TQ15U, SQ17U, SQ15U and LE657U models)

Configuring the TV Setting to Enhance 3D Image Viewing

You can adjust the 3D image to the desired image quality and make various settings for 3D image viewing.

Set AV MODE and "3D Brightness Boost" with "Picture Settings".

Set the 3D viewing settings with "Setup" > "3D Setup".

NOTE

Which items can be selected/adjusted differs depending on whether the TV is in 2D mode or in 3D mode.

AV MODE

The audio and video settings can be changed to suit the program or input content being watched.

3D: For a highly defined image in a normal lighting.

GAME (3D): Lowers image brightness for easier viewing.

For the LE657U model

STANDARD (3D): For a highly defined image in a normal lighting.

MOVIE (3D): For a movie.

GAME (3D): Lowers image brightness for easier viewing.

NOTE

You can select AV MODE by pressing AV MODE on the remote control unit.

3D Brightness Boost

You can adjust the backlight of the TV for 3D image viewing.

High/Middle/Low: Select a desired level of 3D Brightness Boost.

NOTE

When "High" or "Low" is selected, "Automatic Light Sensor", "Backlight" and "Light Sensor Adjustment" are not available.

3D Setup

You can make various settings to enhance 3D image viewing.

3D Auto Change

This setting can be used to switch to 3D mode automatically when a 3D identification signal is detected.

Set the desired mode according to the type of media you are viewing, such as video from a connected device or video from an internet application.

Mode 1: 3D mode is selected automatically when a 3D signal is detected while viewing video from a VOD service or HDMI-connected equipment.

Mode 2: 3D mode is selected automatically when, in addition to detecting a 3D signal while viewing video from a VOD service or HDMI-connected equipment, a video pattern with "Side by Side" or "Top and Bottom" format is also detected.

Off: Auto change is not performed.

NOTE

This function does not work when the input source is Composite, Component, RGB or Analog/Digital tuner.

3D Depth Control

Select the method for adjusting the 3D depth. Auto: The depth is adjusted automatically.

Manual: You can manually adjust the depth using the function "Depth Change".

NOTE

This function is only available when the input signal is 3D.

This function may not be displayed depending on the type of 3D signal.

ENG 5-11