Connecting the Projector to Other Devices
Connecting the Projector to a Computer
Connecting to a Computer Using the RGB Cable
1 Connect the projector to the computer using the supplied RGB cable.
•Secure the connectors by tightening the thumbscrews.
2 To input an audio signal, connect the projector to the computer using
aø3.5 mm audio cable (commer- cially available or available as Sharp service part QCNWGA013WJPZ).
Note
•When connecting the projector to a com- puter in this way, select “RGB” for “Signal Type” in the “Picture” menu. See page 37.
•See page 62 “Computer Compatibility Chart” for a list of computer signals com- patible with the projector. Use with computer signals other than those listed may cause some of the functions to not work.
•A Macintosh adaptor may be required for use with some Macintosh computers. Con- tact your nearest Sharp Authorized Projec- tor Dealer or Service Center.
•Depending on the computer you are using, an image may not be projected unless the signal output setting of the computer is switched to the external output. Refer to the computer operation manual for switching the computer signal output settings.
Supplied | RGB cable | |
accessories | ||
|
Computer
To RGB output terminal
To audio output terminal
1RGB cable
2ø3.5 mm audio cable (commercially available or available as Sharp service part QCNWGA013WJPZ)
Connecting the thumbscrew cables
■ Connect the thumbscrew cable making sure that it fits correctly into the terminal. Then, firmly secure the connectors by tightening the screws on both sides of the plug.
■ Do not remove ferrite cores attached to the RGB cable.
Ferrite core
-16
