Sharp PG-A10X Controlling the Projector Using a Computer, Supplied, accessory, Optional, cable

Connecting the Projector to Other Devices

Controlling the Projector Using a Computer

Connecting to a Computer Using a DIN-D- sub RS-232C Adaptor and an RS-232C Serial Control Cable

When the RS-232C terminal on the projector is connected to a computer with a DIN-D-sub RS- 232C adaptor and an RS-232C serial control cable (cross type, sold separately), the com- puter can be used to control the projector and check the status of the projector. See page 61 for details.

1 Connect the supplied DIN-D-sub RS-232C adaptor to an RS-232C serial control cable (sold sepa- rately).

2 Use the above cables to connect the projector and the computer.

Note

•Do not connect or disconnect an RS-232C serial control cable to or from the computer while it is on. This may damage your com- puter.

•The RS-232C function may not operate if your computer terminal is not correctly set up. Refer to the operation manual of the computer for details.

•See page 60 for connection of an RS-232C serial control cable.

Supplied	DIN-D-sub
accessory	RS-232C adaptor
Optional	RS-232C serial control cable
cable	Type: AN-C10RS (32'10" (10.0 m))
	Computer

DIN-D-sub RS-232C adaptor

RS-232C serial

To RS-232C terminalcontrol cable (sold separately)

-20