Sharp PG-A10X operation manual If You Forget Your Pass- word, Password Setting a Pass- word

Password (Setting a Pass- word)

Apassword must be set to activate the “Anti-Theft” function (Page 48).

There is no factory preset for the password or the “Anti-Theft” settings. In this way, anyone can freely set a new password and “Anti-Theft” settings. It is therefore recommended that even if you do not want to use the “Anti-Theft” function, you at least set a password to prevent others from setting the “Anti- Theft” function.

A password can only be set by using the remote control.

Select “Password” on the “Options” menu,

then press and follow the procedure be- low to enter the password.

1 Press ', "and to enter the pass- word in “Old Password” and press .

2 Press ', " and to set the new

password and press .

3 Enter the new 4-digit password again in “Reconfirm” and press

.

Note

•If you do not want to set a password, leave the

fields in steps 2 and 3 blank and press .

•To cancel the password settings, press .

1 Press ' or " to select the desired number and then press .

2 Enter the 3 remaining digits and

press .

3 Enter the password again in “Recon-

firm” and press .

Note

•When a password is set, you need to enter the password to change the “Anti-Theft” setting.

If you want to change the password, follow the procedure below.

If You Forget Your Pass- word

If you forget the password, delete it using the fol- lowing procedure and set a new password.

Press

Note

•You can only use the buttons on the projector to delete the password.

•The password cannot be deleted using the above described procedures while the “Anti- Theft” function is set. If you forget your pass- word while the “Anti-Theft” function is activated, you will need to contact your nearest Sharp Au- thorized Projector Dealer or Service Center (see page 65). You may need to bring your projector to them to restore the projector to original fac- tory condition (password and keycode reset).

Easy to Use Functions

-47