Keystone Correction (Correcting Trapezoidal Distortion)

Correcting Trapezoidal Distortion

This function allows for Keystone (On-screen Trapezoidal Distortion) Correction.

Note

When the image is projected either from the top or from the bottom towards the screen at an angle, the image becomes distorted trapezoidally.

The function for correcting trapezoidal dis- tortion is called Keystone Correction.

The Keystone Correction can be adjusted up to an angle of approximately ±35 degrees (when the picture display mode is set to “NORMAL” (see page 40)).

KEYSTONE button

UNDO button

', ", \,

buttons

1 Press .

You can also use on the projector.

2 Press ', ", \ and to adjust the Keystone correction.

You can also adjust the Keystone cor-

rection using the or but- tons on the projector.

Note

Since the trapezoidal distortion of the image can be corrected up to an angle of approximately ±35 degrees (when the picture display mode is set to “NORMAL” (see page 40)), the actual screen can be diagonally set up to that angle as well.

Press to make the default set- ting.

Straight lines or the edges of images may appear jagged while adjusting the image.

Compresses upper side.

Compresses lower side.

Basic Operation

3 Press .

You can also use on the projector. Note

You can use the same settings used in NORMAL mode 4:3 for 16:9.

-29

Page 33
Image 33
Sharp PG-A10X operation manual Correcting Trapezoidal Distortion, Press , , \ and to adjust the Keystone correction