Sharp XE-A137 Prior to Programming, Entering character codes with numeric keys on the keyboard

PRIOR TO PROGRAMMING

■■ Procedure for programming

1.Check to see whether a paper roll is present in the machine. If there is not enough paper on a roll, replace it with a new one (refer to “Replacing the Paper Roll” in “OPERATOR MAINTENANCE” chapter on page 78 for the replacement).

2.Put the mode key in the mode switch and turn it to the Z/PGM position.

3.Program necessary items into the cash register. Every time you program an item, the cash register will print the setting. Please refer to print samples in each section.

4.If necessary, issue programming reports for your reference.

NOTE • On the key operation example shown in the programming details, numbers such as “221012” indicates the parameter which must be entered using the corresponding numeric keys.

• Asterisks in the tables shown in the programming details indicate default settings.

■■ Entering character codes with numeric keys on the keyboard

Numerals, letters and symbols are programmable by entering the :key and character codes. Use the following procedure.

XXX : XXX : character code (3 digits)

For the character codes, please refer to the character code table on the next page. By doing this, you can program characters other than those on the key tops. For entering numerals and letters using character keys, refer to “Guidance for text programming”.

•Double-size characters can be made by entering the character code 255 or pressing the Wkey. The “_” symbol lights up in the display when double-size characters entry is selected as shown in the example below.

•All three digits of the character code must be entered (even if it starts with zero).

Example

To program the word “SHARP” in double-size characters

255 :083 :255 :072 :255 :065 :255 :082 :255 :080 :

SHARP

43