Checking the current EURO status
You can check the EURO status currently set on the cash register. Turn the mode switch to the X/Flash position, and perform the following sequence. The current EURO status will be printed on the receipt.
800 
@
A
EURO status
■■ Optional Programming for the Introduction of EURO
Some programming relating with the function of exchange key (V) cannot be changed automatically with the execution of modification operation described in the previous section. After the execution on each period, conduct the following programming depending on your needs.
Programming for Exchange Key (V)
Currency exchange rate
For period 1 and period 2, set the EURO conversion rate.
For programming details, refer to “Rate for %and V” on page 45.
Exchange rate entry selection
When you treat EURO currency in the exchange key, you can use the Vkey function. For programming details, refer to “Function parameters for V” on page 47.
Cheque/credit operation
For period 1 and period 2, enable cheque/credit operation when tendering in foreign currency so that you can treat cheque and credit for EURO currency and national currency. For programming details, refer to “EURO system settings” on page 63.
Setting the date and time when the automatic modification operation for EURO should be executed Selection of
You can program the scheduled date and time to execute the automatic EURO modification operation (for programming details, refer to page
From ten days before the preset date, the remaining days are printed at the bottom of the daily full resetting (Z1) report as follows.
Preset date and time
Remaining days
When the
the error symbol “
” is displayed. You cannot make any operation in the REG mode until you execute the automatic modification operation for EURO (job #800) in the Z/PGM mode.
You can program so that you can make entries in the REG mode even when the error symbol is displayed. Date and time setting will be reset after the execution of the automatic modification operation and you can program again the date and time for the next automatic modification operation.
73
