Connecting to a Computer

Ensure that the computer is the last device to be turned on after all the connections are made.

Connecting to a Computer Using a DVI Cable

Computer

To DVI terminal

To DVI Digital output terminal

DVI cable

(sold separately: AN-C3DV)

Note

•When connecting the projector to the video equipment in this way, select “Signal Type” in the “Options” menu. See page 44.

Connecting to a Computer Using the DVI to 15-pin D-sub Adaptor and the RGB Cable

Computer

To DVI terminal

To RGB output terminal

RGB cable (commercially available)

Connections

DVI to 15-pin D-sub adaptor (sold separately: AN-A1DV)

Note

•When connecting the projector to the video equipment in this way, select “Signal Type” in the “Options” menu. See page 44.

•Refer to “Computer Compatibility Chart” on page 60 for a list of computer signals compatible with the projector. Use with computer signals other than those listed may cause some of the functions not to work.

•A Macintosh adaptor may be required for use with some Macintosh computers. Contact your nearest Sharp Authorized Service Center or Dealer.

•Depending on the computer you are using, an image may not be projected unless the computer’s external output port is switched on. (e.g. Press “Fn” and “F5” keys simultaneously when using a SHARP notebook computer). Refer to the specific instructions in your computer’s operation manual to enable your computer’s external output port.

-23