
Problem | Check | Page |
The black levels of the | • Make adjustments that result in the best picture quality in the | 44 |
image show banding | “Dynamic Range” setting. |
|
or appear faded when |
|
|
HDMI1 or 2 is selected. |
|
|
|
|
|
Picture is too bright and | • Picture adjustments are incorrectly set. | 36 |
whitish. |
|
|
|
|
|
The cooling fan | • When temperature inside the projector increases, the cooling | – |
becomes noisy. | fan runs faster. |
|
|
|
|
The lamp does not light | • The lamp indicator is illuminating in red. | 46,49 |
up even after the | Replace the lamp. |
|
projector turns on. |
| |
|
| |
|
|
|
The lamp suddenly turns |
|
|
off during projection. |
|
|
|
|
|
The image sometimes | • Cables incorrectly connected to the projector or the connected | |
flickers. | equipment works improperly. |
|
| • If this happens frequently, replace the lamp. | 49 |
|
|
|
The lamp needs much | • The lamp will eventually need to be changed. | 49 |
time to turn on. | While the remaining lamp life draws to a close, replace the |
|
Picture is dark. | lamp. |
|
|
| |
|
|
|
A response code cannot | • In the case of transmitting | 52 |
be received when the | during standby, it takes a maximum of 30 seconds for the computer |
|
projector was attempted | to receive the response code. Set the response code waiting time of |
|
to be controlled using | the computer to 30 seconds or more. |
|
|
| |
from a computer during |
|
|
standby. |
|
|
|
|
|
The remote control | • Operate the remote control while pointing it at the projector’s | 11 |
cannot be used. | remote control sensor. |
|
| • The remote control may be too far away from the projector. | 11 |
| • If direct sunlight or a strong fluorescent light is shining on the | 11 |
| projector’s remote control sensor, place the projector where it |
|
| will not be affected by strong light. |
|
|
|
|
| • The batteries may be depleted or inserted incorrectly. Make | 11 |
| sure the batteries are inserted correctly or insert new ones. |
|
|
|
|
This unit is equipped with a microprocessor. Its performance could be adversely affected by incorrect operation or interference. If this should happen, unplug the Unit and plug it in again after more than 5 minutes.
Service Information (for the U.S.)
For the location of the nearest Sharp Authorized Service Center or Dealer, or to obtain product litera- ture, accessories, supplies or customer assistance, please call
-62