Controlling the Projector by a Computer
When the RS-232C terminal on the projector is connected to a computer, the computer can be used to control the projector and check the status of the projector.
When connecting to a computer using an RS-232C serial control cable
Computer
To RS-232C terminal
To RS-232C terminal
RS-232C serial control cable (cross type, commercially available)
Note
•The RS-232C function may not operate if your computer terminal is not correctly set up. Refer to the operation manual of the computer for details.
•For details on RS-232C specifications and commands, see page 52.
Info
•Do not connect the RS-232C cable to a port other than the RS-232C terminal on the computer. This may damage your computer or projector.
•Do not connect or disconnect an RS-232C serial control cable to or from the computer while it is on. This may damage your computer.
-24