Removing and Installing the Lamp Unit

•The lamp unit becomes very hot while the projector is operating. Do not remove the lamp Warning! unit from the projector right after use. The lamp and parts around the lamp will be very

hot and may cause burns or injury.

Info

•Be sure to remove the lamp unit by the han- dle. Be sure not to touch the glass surface of the lamp unit or the inside of the projector.

•To avoid injury to yourself and damage to the lamp, be sure to carefully follow the steps below.

•Do not loosen other screws than for the lamp unit cover and lamp unit.

(As for the lamp unit, only the silver screws are loosened.)

1Press STANDBY on the pro- jector or STANDBY on the re- mote control to put the projector into the standby mode.

•Wait until the cooling fan stops.

Optional

Lamp unit

accessory

(Type: AN-K20LP)

STANDBY

STANDBY button

2Disconnect the power cord.

•Unplug the power cord from the AC socket.

•Leave the lamp until it has fully cooled down (about 1 hour).

3Remove the lamp unit cover.

•Loosen the user service screws that secure the lamp unit cover. Then open the cover in the direction of the arrow.

4Remove the lamp unit.

•Loosen the securing screws from the lamp unit. Hold the lamp unit by the handle and pull it in the direction of the arrow.

AC socket

User service screws

Lamp unit cover

Lamp unit

Securing screw

Handle Securing screws

Appendix

-49