Turning the Projector On/Off

Connecting the Power Cord

Plug the supplied power cord into the AC socket on the rear of the projector.

•The power indicator illuminates red, and the projector enters standby mode.

Turning the Projector On

Before performing the steps in this section, connect any equipment that you use with the projector. (See pages 18-25.)

Remove the lens cap and press ON on the projector or ON on the remote control.

•The power indicator illuminates blue.

Note

•About the Lamp Indicator

The lamp indicator illuminates to indicate the status of the lamp.

Blue: The lamp is ready.

Blinking in blue: The lamp is warming up.

Red: The lamp is shut down abnormally or the lamp should be replaced.

•When switching on the projector, a slight flickering of the image may be experienced within the first minute after the lamp has been illuminated. This is normal operation as the lamp’s control circuitry is stabilizing the lamp output characteristics. This does not indicate malfunction.

•If the projector is put into standby mode and immediately turned on again, the lamp may take some time to illuminate.

Supplied

Power cord

accessory

 

Info

•English is the factory preset language. If you want to change the on-screen display to another language, change the language according to the procedure on page 45.

Power indicator

Lamp indicator

ON

STANDBY

ON button

STANDBY button

Lens cap

Operation Basic

-25