Siemens 6ED1050-1AA00-0BE8 manual Assigning a security function, Enabling the security function

Applicable cards

8.1 Security function (CopyProtect)

Assigning a security function

To assign a circuit program and copy protection function to the card, open the programming mode and select "Card".

1.Switch LOGO! to programming mode (ESC / >Stop).

2.Select the 'Card' command: Press or

3.To apply 'Card': Press OK

4.Move the '>' cursor to 'CopyProtect': Press or

5.To apply 'CopyProtect': Press OK

LOGO! shows the following display:

!1R <HV &RS\3URWHFW 1R

The current protection setting is shown in the bottom line. This function is disabled by default ("No": disabled).

Enabling the security function

To set the security function:

1.Move the '>' cursor to 'Yes': Press or

2.Confirm 'Yes': Press OK

LOGO! shows the following display:

!1R <HV &RS\3URWHFW <HV

Note

This only generates a circuit program and copy protection for the card; the circuit program itself must be copied (Page 309) separately from LOGO! to the card. (This copy can be done at power-on.)

You can always change the "No" status (security function disabled) to "Yes" (security function enabled).

A status change from "Yes" (security function enabled) to "No" (security function disabled) is only possible if the card does not contain a circuit program.

	LOGO!
306	Manual, 04/2011, A5E03556174-01