Siemens 6ED1050-1AA00-0BE8 manual Deactivating the password from the LOGO! Basic

Programming LOGO!

3.7 Writing and starting the circuit program

Deactivating the password from the LOGO! Basic

To deactivate the password to allow, for example, another user to edit your circuit program, you must know your current password (in our example "ZZ"), the same as if you were changing it.

To deactivate the password, follow these steps in the programming menu:

(GLW

&OHDU3UJ !3DVVZRUG

0VJ&RQILJ



1.Move the '>' cursor to "①": Press or

2.Confirm "①": Press OK

Enter your current password as described in steps 3 to 5 above. Confirm your entries with OK.

The display shows:

2OG

==

1HZ

Clear the password by leaving the input box blank:

3. Confirm the "blank" password: Press OK

The password is "cleared", and LOGO! returns to the programming menu.

Note

This action disables the password prompt, and thus permits access without a password.

Leave the password deactivated for quicker progress through the remaining exercises and examples.

Password: Wrong Password!

If you enter the wrong password and confirm the input with OK, the LOGO! Basic does not open editing mode, but returns to the programming menu. This repeats itself over and over again until you enter the correct password.

	LOGO!
94	Manual, 04/2011, A5E03556174-01