Siemens 6ED1050-1AA00-0BE8 manual Inserting and removing the card from Logo

Applicable cards

8.2 Inserting and removing the card from LOGO!

8.2Inserting and removing the card from LOGO!

When you remove a LOGO! memory card, a combined memory/battery card, or an SD card that contains a circuit program with copy protection attributes, note the following: The circuit program stored on the card can only be executed if the card remains inserted during system runtime.

After you have removed the card, LOGO! outputs the message 'No Program'. A removal of the card during RUN will lead to impermissible operating states.

Always heed the following warning:

WARNING

Do not touch the open slot of the memory card or SD card with your fingers or with a metallic or conductive object. Death or personal injury may result.

The memory card/SD card socket might be under voltage if the polarity is accidentally reversed at L1 and N.

The memory card, battery card, or combined memory/battery card must only be removed by qualified personnel using the directions below.

Removing the memory card, battery card or combined memory/battery card

To remove the memory card, carefully insert a screwdriver with a 3-mm blade into the groove on the upper end of the card, and lever the module partially out of the slot. You can now remove the memory card.

LOGO!
Manual, 04/2011, A5E03556174-01	307