Silex technology PRICOM SX-300U user manual CHECK1

Users Manual SX

PRICOM is not found even after searching in the configuration utility (Quick Setup, AdminManager) or PRICOM is not recognized on the network

CHECK1

Check the followings and retry the configuration.

-Verify that the printer for an internal PRICOM is turned on or the PRICOM power is turned on.

-Print the self-diagnostic and configuration report. If NG is printed, refer to "NG is printed in the diagnostic report." on page 3 of this chapter.

-Verify the parameters on the configuration report are configured correctly.

-For printing self-diagnostic/configuration report, refer to chapter 2.

NOTE

CHECK2

-Verify that the LINK LED of PRICOM and the Ethernet HUB are blinking. If not, verify the proper network cable connection.

-Verify that the Ethernet HUB is working properly.

CHECK3

When operating in Windows environment, run AdminManager and click Option, then search using TCP/IP protocol. When operating in NetWare environment, click Search using IPX/SPX protocol, and search for the PRICOM again.

CHECK4

When you use TCP/IP protocol in Windows XP environment, click Local Area Connection Properties, then Advanced, then remove the check from Protect my computer and network by limiting or preventing access to this computer from the Internet.

FAQ 10-2