Silex technology PRICOM SX-300U user manual TCP/IP Setup, Explanation Factory Default

Users Manual SX

TCP/IP Setup

Tab

TCP/IP

Item	Explanation	Factory
		Default
Use TCP/IP Protocol	Enable/Disable TCP/IP protocol operations. This
	has influence on the configuration of Setup Tools,	ENABLE
	LPR, FTP, TELNET, SNMP, HTTP and other
	protocols over TCP/IP.
Use DHCP/BOOTP	Enable/Disable DHCP/BOOTP protocol operations.
	DHCP/BOOTP is a protocol, via which IP address
	gets assigned by the BOOTP server or DHCP
	server. If you use DHCP/BOOTP server, the
	DHCP/BOOTP server must be in the same	ENABLE
	segment as the print server. This print server
	detects DHCP and BOOTP automatically. If more
	than 1 address is returned, the IP address which is
	returned first will be used.
Use RARP	Enable/Disable RARP protocol operations. RARP
	is a protocol, via which the IP address gets
	assigned by the RARP server. If you use a RARP	ENABLE
	server, the RARP server must be in the same
	segment as the print server.
IP Address	Setting the Print Server IP address. The IP address
	must be 4 numbers, each between 0-255 (eg.	0.0.0.0
	192.168.100.10).
Subnet Mask	Setting the print server subnet mask. The subnet
	mask must be 4 numbers, each between 0-255
	(eg. 255.255.255.0). However, entering 0.0.0.0	0.0.0.0
	would not be valid, and the subnet mask
	corresponding to the IP address would be used
	automatically.
Default Gateway	Setting the default gateway address. The default
	gateway address must be 4 numbers, each
	between 0-255 (eg. 192.168.100.240). If you use a	0.0.0.0
	gateway, the gateway must be in the same
	segment as the print server.
Use FTP/LPD Banner	You can select to use a banner page when printing
	with LPR and FTP. (A banner page is print cover	DISABLE
	page with print job explanations.)

Appendix 7