X-Shop Jigsaw Operation

The following Skil Jigsaw models may be used with the jigsaw insert: Models 4280, 4380, 4390, 4480, 4540, 4580 & 4680.

!WARNING

Turn main power off and make sure that the table saw

blade is not spinning before using X-shop accessory power tools. Contact with an unattended and spinning blade can cause injury.

• Before making adjustments, make sure the jigsaw switch is in the OFF position and the cord is unplugged.

• Lower the table saw blade below table before using the accessory power tools.

• Remove X-Shop tool inserts and reinstall blank inserts before returning to table saw operation.

• If jigsaw is equipped with a laser system, make sure that

FIG. 79

the laser is turned off. Direct Exposure to the laser light

 

can cause damage to your eyes. See the Jigsaw manual

 

for a complete listing of laser safety and operating

 

instructions.

 

Note: See page 9 for Jigsaw Safety.

1.The saw does not cut wood by itself. You allow the saw to cut wood by guiding the wood into the blade as it moves.

2.The blade teeth cut ONLY on the down stroke.

3.You must feed the wood into the blade slowly because the teeth of the blade are very small and they can only remove wood when they are on the down stroke. The blade will flex backwards when applying feed pressure. Too much feed pressure will cause blade breakage.

4.Best results are achieved when cutting wood less than 1" thick.

5.Teeth on jigsaw blades wear out and blades must be replaced frequently for best cutting results.

6.Metal should not be cut with this jigsaw.

NOTE: SEE JIGSAW OWNER’S MANUAL FOR MORE

INFORMATION.

102.

Page 102
Image 102
Skil 3700 manual Shop Jigsaw Operation