
Attaching Sander Insert
The following Skil Sander Models may be used with the sander insert: Models 7313 & 7500.
! | WARNING | BEFORE USING THE SANDER: Read the | |
instruction manual that came with the | |||
|
|
sander.
From among the loose parts, locate the following hardware (Fig. 25).
Item | Description | Quantity |
S1 | Sander Insert | 1 |
S2 | Sander Bracket Right | 2 |
S3 | Sander Bracket Front | 1 |
S4 | Sander Bracket Left | 2 |
S5 | 2 | |
S6 | Wing Nut | 10 |
S7 | Washer | 10 |
S8 | Retaining Bracket | 1 |
S9 | Sander Fence | 1 |
S10 | Wear Bracket | 2 |
S11 | 8 |
Note: There are two sets of support brackets (S2 & S4) depending on which sander model is being used.
1.Make sure the sander switch is in the OFF position and the cord is unplugged.
2.Install sanding belt per the sander’s original instruction manual.
3.Attach sander wear brackets S10 to insert. (Fig. 25)
4.Fasten the right and left sander brackets S2, S4 to the insert using 4
5.Insert the sander, making sure that the tabs YY on the flat brackets engage with the four slots XX on the sides of the sander (Fig. 26).
6.Install the front bracket S3 using 2
7.Attach retaining bracket S8 onto bottom of insert using hex- head screws S11, washers S7 and wing nuts S6 as shown.
8.Lift the red latch lever Y located at front of the wing opening. The sander insert may be installed in the right or left wing.
9.Slip tabs X on edge of insert into rear of wing opening. (Fig. 27)
10.Lower the front edge of insert S1 into wing and lower the red latch lever Y. (Fig. 28)
11.Install the fence S9 using the two wing nuts shown. (Fig. 28)
12.Lock the sander switch to the ON position.
13.Make sure the main table saw power switch is in the OFF position.
14.Insert the router electrical plug into the accessory power outlet.
15.See the section on “Operation of the Accessory Power Outlet”.
16.Lower the saw blade below the table before operating the sander.
17.Operate the sander in accordance with the sections entitled “Sander Safety” and “Operation of a Sander with the Sander Insert” in this manual.
FIG. 28
Y
S9
FIG. 25 |
|
| S11 |
|
|
| |
| S9 |
|
|
|
|
| S8 |
|
|
| S7 |
|
|
| S6 |
|
|
| S11 |
S5 |
|
| S1 |
|
|
| |
|
|
| S10 |
|
| S2 |
|
| S4 |
|
|
|
|
| S7 |
|
|
| S6 |
| x5 | S3 |
|
|
|
| |
FIG. 26 |
|
| (Tool not included) |
|
|
| (Outil non joint) |
|
| (Herramienta no incluida) | |
XX |
|
|
|
| yy |
|
|
S4 |
|
|
|
X |
| 2 | Y |
|
| ||
FIG. 27
56.