Skil 3700 manual Jigsaw Safety

Jigsaw Safety

The following Skil Jigsaw Models may be used with the jigsaw insert: Models 4280, 4380, 4390, 4480, 4540, 4580 & 4680.

Make certain all adjusting screws and the blade holder are tight before making a cut. Loose adjusting screws and holders can cause the tool or blade to slip and loss of control may result.

Be sure to keep both hands on the workpiece. Whenever possible use a push piece.

Keep firm downward pressure to prevent workpiece from being raised from table surface. Small or thin material may flex or vibrate with the blade, causing loss of control.

When removing the blade from the tool avoid contact with skin. Use proper protective gloves when grasping the blade or accessory. Accessories may be hot after prolonged use.

Avoid awkward operations and hand positions and always make sure you have good balance. A sudden slip could cause your hand to move into the blade.

Before making a cut, be sure all adjustments are secure. Loose table or guards could shift in use and cause you to loose control of the workpiece.

Always support large workpieces while cutting to minimize risk of blade pinching and kickback. Heavy workpiece may cause the table to slip, walk or slide while cutting.

Be sure the blade path is free of nails. Inspect for and remove nails from lumber or workpiece before cutting or sanding.

Never start the tool when the blade is in contact with the workpiece. Allow the motor to come up to full speed before starting a cut. Blade in contact with the workpiece on start up will cause it to jump.

Use caution when cutting materials with an irregular cross- section or rounds like dowel rods. If possible lay the material on its "flat" side when cutting. For round stock use a "Vee" block to support the material. Wavy material like molding will tend to rock and may bind while cutting. Rounds will tend to roll while being cut and the blade may "bite" and grab it from your control.

If jigsaw is equipped with a laser system, make sure that the laser is turned off. Direct Exposure to the laser light can cause damage to your eyes. See the Jigsaw manual for a complete listing of laser safety and operating instructions.

9.