26 | CHAPTER 3 – CABLING AN 880i4 OR 885i4 SYSTEM TO A HAWM-UX/UF
Connecting your SMART UF65 or SMART UF65w projector’s ECP harness cable
The ECP harness cable controls all signals and commands sent between the ECP
and the projector. Choose a side of the interactive whiteboard to install your ECP on,
and then follow the instructions in theSMART Board X880i4 Interactive Whiteboard
System Configuration and User’s Guide (smarttech.com/kb/150699).
To connect your
projector’s ECP harness
cables
1. Pass the ECP cable throug h the
cable slot.
NOTE
The upper part of the ECP
cable is too thick to fit inside
the cable slot, so put the
thinner part of the ECP cable
in the cable slot.
2. From the ECP harness cable,
attach the DB9 connector, the
4-pin power mini-DIN connector
and the 7-pin mini-DIN
connector to the projector’s
connection panel.
3. Attach the screw on the ECP
strain relief to the projector
housing using a Phillips No. 2
screwdriver.
4. Place the harness cable around
the back of the HAWM-UX/UF,
toward the left side of the
interactive whiteboard for
proximity to the left-mounted
ECP.
5. Place the harness cable through the upper cable clips you installed on the side of
the HAWM-UX/UF.
6. Connect the harness cable’s DB15M plug to the ECP’s DB15 connector.