68 | CHAPTER 6 – CABLING A 600I3 OR D600I3 SYSTEM TO A HAWM-UX/UF
Cables for peripheral devices connected to the projector but not mounted on the
HAWM-UX/UF are at the greatest risk of damage, because they shift as the
HAWM-UX/UF rises and descends. These peripheral devices and cables include the
following:
• your ECP harness cable
• your computer or SMART Hub VE220 or SE240 collaboration platform
NOTE
Both the VE220 and SE240 models include 72" (183 cm) output cables to
connect to your projector. You might need cable extensions (not included)
may be required.
• a room control device
• a network cable
• the projector’s power cable
When connecting these peripheral devices, make sure there’s enough slack, mount
the peripheral device to a permanent location and make sure there are no
obstructions in the cable path. Cable friction, rubbing and strain can occur if you don’t
take the proper precautions.
Mounting and connecting your SMART UF55 or SMART
UF55w projector’s ECP harness cable
Before you mount any cables to your projector, you must mount the SMART UF55 or
SMART UF55w projector’s ECP to the wall (not to the HAWM-UX/UF). You must
carefully attach the ECP at the location specified in the instructions below. Refer to
your SMART Board 680i3 and D680i3 Interactive Whiteboard System Installation
Guide (smarttech.com/kb/131457) and the SMART Board 600i2 and 600i3 Series
Interactive Whiteboard System Extended Control Panel (ECP) Installation Template
(smarttech.com/kb/118881) for additional instructions.
NOTE
You must have your interactive whiteboard placed on the HAWM-UX/UF before
you begin this procedure. The HAWM-UX/UF should be at its highest position
before you start measuring.
To mount your projector’s
ECP harness cable
1. Choose a side of the interactive whiteboard to install your ECP beneath. Consider
the distance to your peripheral devices and inputs when making this decision.