57 | CHAPTER 5 – CABLING A 600I4 OR D600I4 SYSTEM TO A HAWM-UX/UF
Connecting your SMART UF65 or SMART UF65w projector to the SBA-L projection audio system
The HAWM-UX/UF is designed to accommodate mounting the SBA-L projection audio
system directly to the interactive whiteboard. That way, when the speakers rise and
descend with the HAWM-UX/UF’s and interactive whiteboard’s movement, there’s
less risk of damage to the audio connection and power cables. Therefore, SMART
recommends that you don’t mount the SBA-L Projection Audio System to the wall.
Before connecting the audio system to the projector, you must install the speaker
brackets, speakers and speaker cable clips according to the SBA-L Projection Audio
System Installation Instructions (smarttech.com/kb/142552).
To connect your projector
to your speakers
1. Retrieve the 3.5 mm jack to dual channel audio output (two RCA jacks) cable from
the SBA-L packaging.
2. Pass the audio connection cable through the boom. Place the cables in the left
side of the cable slot.
3. Connect the audio connection cable to the projector’s connection panel.
4. Place the audio connection cable through the
right speaker cable clip on the rear of the
interactive whiteboard, toward the right
speaker.
5. Connect the dual channel audio output to the
speaker’s connection panel, and bundle any
excess cable in the right speaker cable clip.
6. Retrieve the speaker-to-speaker Molex
(double-barreled) cable from the SBA-L
packaging.
Right speaker
cable clip