54 | CHAPTER 5 – CABLING A 600I4 OR D600I4 SYSTEM TO A HAWM-UX/UF
Placing cables for HAWM-UX/UF-mounted
components
To prevent cable friction, SMART recommends that you first place the cables that
don’t shift after they’re installed. Cables that connect components mounted to the
HAWM-UX/UF don’t shift after they’re installed. To prevent cable friction, SMART
recommends that you place these cables first.
Using the SMART UF65 and SMART UF65w projector connection panel for HAWM-UX/UF-mounted components
The following diagram and list identify the SMART UF65 and SMART UF65w projector
connections to HAWM-UX/UF-mounted components.
To access the projector connection panel and wire management clip, remove the
input/output cover on the left side of the projector and remove the cable covers. For
more information, see the SMART Board 600i4 and D600i4 Interactive Whiteboard
System Configuration and User’s Guide (smarttech.com/kb/146184).
Number Function
1 4-pin power mini-DIN 5V/2A connector (reserved for ECP harness
cable)
2 7-pin mini-DIN connector (reserved for ECP harness cable)
3 RCA jack composite video input (reserved for ECP harness cable)
4 RCA jack audio left/right input (reserved for ECP harness cable)
5 3.5 mm audio output connector (recommended for SBA-L speakers)
1 2 3 54