69 | CHAPTER 6 – CABLING A 600I3 OR D600I3 SYSTEM TO A HAWM-UX/UF
2. Draw a line on the wall behind the interactive whiteboard on the appropriate side,
36" (91.4 cm) from the floor, using a pencil and level.
a. If you choose the left side, locate the lower left hand side of the interactive
whiteboard and draw a line 1" (2.5 cm) from the left of the interactive
whiteboard. This mark is for the top right screw’s drill hole on the ECP.
b. If you choose the right side, locate the lower right hand side of the interactive
whiteboard and draw a line 1" (2.5 cm) from the right of the interactive
whiteboard. This mark is for the top left screw’s drill hole on the ECP.
3. Retrieve your ECP template and textless installation instructions, from the
SMART UF55 or SMART UF55w projector packaging.
4. On the appropriate side, make a hole in the ECP template’s screw hole mark.
5. Place the ECP template’s screw hole mark on top of the drill hole mark you
created in step 2. Align the center of the screw hole to the drill hole mark. Level
the ECP template and tape it securely.
6. Drill the ECP template at all four drill hole locations, following the
recommendations on the ECP template for the drill bit size. Remove the ECP
template from the wall when you finish drilling and discard it.