76 | CHAPTER 6 – CABLING A 600I3 OR D600I3 SYSTEM TO A HAWM-UX/UF
9. Attach a cable management clip (not included) to the cables or cable bundles,
making sure there’s a minimum of 28" (71.1 cm) excess straight length or a 14"
(35.6 cm) loose loop of cable.
10. If you don’t want to connect a network cable, proceed to the next step. Otherwise,
connect the other end of the network cable to your LAN port.
11. Connect the HD-DB15 (VGA) connector and the DB25 connector from the
harness cable to the ECP.
12. Slowly test the
movement of the unit,
using the HAWM-UX/
UF’s mobility switch.
Make sure the cables
aren’t taut at any range
of the HAWM-UX/UF’s
movement. If they’re
still taut, repeat this
procedure until you find
a suitable mounting
location or length for
the cables.
Connecting your host computer to the projector or ECP
You must connect your host computer’s video and audio outputs to your SMART
UF55 projector, or SMART UF55w projector, or ECP.
If you use guest computers, SMART recommends that you install your host
computer’s video output to your projector and reserve the VGA connector on the ECP
for a guest computer connection, such as a laptop.
If you don’t use guest computers, SMART recommends that you install your host
computer’s video output to the VGA connector on the ECP. This makes the cable
installation of SMART UF55 and SMART UF55w projectors much simpler.
Use only one set of the following instructions for your specific installation: