28 | CHAPTER 3 – CABLING AN 880i4 OR 885i4 SYSTEM TO A HAWM-UX/UF
Connecting your SMART UF65 and SMART UF65w projector to the pen tray audio jack
The audio and power jacks are located beside each other on the back of the pen tray.
To connect the projector
to the audio jack
1. Connect the ends of the stereo Y cable to the VGA 1 and the VGA 2 inputs on
your UF65 or UF65w projector.
2. Connect the other end of the stereo Y cable to the audio jack on the back of your
interactive whiteboard’s pen tray.
Connecting your SMART UF65 or SMART UF65w projector to the SBA-L projection audio system
HAWM-UX/UF is designed to accommodate mounting the SBA-L projection audio
system directly to the interactive whiteboard. That way, when the speakers rise and
descend with the HAWM-UX/UF’s and interactive whiteboard’s movement, there’s
less risk of damage to the audio connection and power cables. Therefore, SMART
recommends that you don’t mount the SBA-L projection audio system to the wall.
Before connecting the audio system to the projector, you must install the speaker
brackets, speakers and speaker cable clips according to the SBA-L Projection Audio
System Installation Instructions (smarttech.com/kb/142552).
To connect your projector
to your speakers
1. Retrieve the 3.5 mm jack to dual channel audio output (two RCA jacks) cable from
the SBA-L packaging.
2. Pass the audio connection cable through the boom. Place the cables in the left
side of the cable slot.
3. Connect the audio connection cable to the projector’s connection panel.
Audio
jack
Power
jack