74 | CHAPTER 6 – CABLING A 600I3 OR D600I3 SYSTEM TO A HAWM-UX/UF
To connect your projector
power cable
1. Pass the power cable
through the boom and
then connect it to the
power socket. Make
sure that the power
cable is in the far right
position in the cable
slot.
2. Secure the po wer cable to the SMART UF55 or SMART UF55w projector’s wall-
mount bracket using a cable tie. Place the cable through the cable cutouts on the
wall-mount bracket.
3. Place the power cable around the back of the HAWM-UX/UF’s interactive
whiteboard brackets toward the left side of the interactive whiteboard if the power
outlet is located on the left or toward the right side of the interactive whiteboard if
the power outlet is located on the right.
4. Connect the other end of the power cable to a power outlet no more than 72"
(183 cm) away from the projector. This distance includes the amount of slack you
need for the projector’s range of movement. If necessary, use a power cable
extension of an appropriate length that includes a minimum of 28" (71.1 cm)
excess straight length or a 14" (35.6 cm) loose loop of cable.
5. Slowly test the movement of the unit, using the HAWM-UX/UF’s mobility switch.
Make sure the cable isn’t taut at any range of the HAWM-UX/UF’s movement.
TIP
Find a support location for the power cable that doesn’t interfere with the
movement of the HAWM-UX/UF and attach a cable management-clip (not
included) to the cable. Make sure that you have enough slack for the
HAWM-UX/UF to move freely and then bundle the excess. This is highly
recommended.
To connect your
projector’s network and
ECP harness cables on
the HAWM-UX/UF
1. If you don’t want to connect a network cable, proceed to the next step. Otherwise,
make sure you have a network cable with RJ45 plugs (not included) long enough
to connect your projector to a LAN port.
Cable slot