33 | CHAPTER 3 – CABLING AN 880i4 OR 885i4 SYSTEM TO A HAWM-UX/UF
To connect your projector
power cable on the
HAWM-UX/UF
1. Pass the power
cable through the
boom and then
connect it to the
power socket. Make
sure that the power
cable is in the far
right position in the
cable slot.
2. Place the power cable around the back of the HAWM-UX/UF toward the left side
of the interactive whiteboard if the power outlet is located on the left, or toward the
right side of the interactive whiteboard if the power outlet is located on the right.
3. Connect the other end of the power cable to a power outlet no more than 72"
(183 cm) away from the projector. This distance includes the amount of slack you
need for the projector’s range of movement. If necessary, use a power cable
extension of an appropriate length that includes a minimum of 28" (71.1 cm)
excess straight length or a 14" (35.6 cm) loose loop of cable.
4. Slowly test the movement of the unit, using the HAWM-UX/UF’s mobility switch.
Make sure the cable isn’t taut at any range of the HAWM-UX/UF’s movement.
TIP
Find a support location for the power cable that doesn’t interfere with the
movement of the HAWM-UX/UF and attach a cable management-clip (not
included) to the cable. Make sure that you have enough slack for the
HAWM-UX/UF to move freely and then bundle the excess. This is strongly
recommended.
To connect your
projector’s network and
peripheral device cables
on the HAWM-UX/UF
1. If you don’t want to connect a network cable, proceed to step 3. Otherwise, make
sure you have a network cable with RJ45 plugs (not included) long enough to
connect your projector to a LAN port.
2. Pass the network cable through the boom and connect the RJ45 plug on the
network cable to the RJ45 port on the projector. Make sure that the network cable
is in the middle left position in the cable slot.
3. Pass peripheral device cables through the boom. Make sure that the peripheral
device cables are in the middle left position in the cable slot.
4. Connect your peripheral device cables to the appropriate locations on the
projector’s connection panel (see page30).
5. If you don’t want to connect a network cable, proceed to the next step. Otherwise,
connect the RJ45 plug on the network cable to the RJ45 port on the projector,
making sure that the network cable is in the middle left position in the cable slot.
Cable slot