SMC Networks EX500-GEN1 instruction manual

Reduced wiring system

EX500

GEN1

Instruction Manual

EtherNet/IP™ Compatible GW Unit

Specifications are subject to change without prior notice and any obligation on the part of the manufacturer.

EtherNet/IP™ is a trademark used under licence by ODVA.

The descriptions of products shown in this document may be used by the other companies as their trademarks.

URL http://www.smcworld.com

Contents

Main Reduced wiring system Instruction Manual OPERATOR Contents SAFETY IMPORTANT MESSAGES NOTE Handling precautions SAFETY ( continued ) Product Summary System configuration general GW unit Manifold valve with SI unit ( SV/VQC series ) Manifold valve with SI unit ( SV/VQC series ) EX500 Part Names EX500 body Installation ( unit : mm ) Thread mounting 8 9 () Higher-level bus I/O mapping Input area mapping Status input area specifications 10 11 Specification ( continued ) The wirings is explained in the following order. Power supply connector Power supply for output Power supply for input and controlling GW/SI 12 13 Communication wiring Pin layout and connection diagram of cable with Ethernet communication connector Power supply wiring Pin layout and connection diagram of power supply connector cable for ( unit :mm ) 14 15 Separate wiring for power supply for solenoid valves/output and for input and control of GW/SI Branch wiring 16 17 Wiring (continued ) For GW unit Manifold valve Input unit manifold configuration For GW unit Input unit manifold configuration Type, pin layout and connection diagram of the branch cable with M12 connector ( EX500-AC - ) 18 19 Display/Switch Setting Display Switch setting ON SI Unit Part Names 1. SI unit for SV series valves ( EX500-S 01 ) 2. SI unit for VQC series valves ( EX500-Q ) Display/Switch Setting (continued ) *1 : Remote control (SW1 all dip-switches off) Mounting/Wiring The mounting and removing methods of SI unit are as shown below. ( EX500-Q 02 ) SI Unit for VQC Series Valves ( EX500-Q 01 ) SI Unit for SV Series Valves ( EX500-S 01 ) SI unit for SV series valves ( EX500-S 01 ) SI unit for VQC series valves ( EX500-Q ) 1. SI unit for SV series valve ( EX500-S 01 ) 2. SI unit for VQC series valve ( EX500-Q ) 3. Applicable valve series Input Unit Manifold Part Names Specifications for Input unit Dimensions ( unit : mm ) (continued ) Installation Specifications for input block When only input blocks for M12 connector are connected Correspondence between input number and input block Branch wiring Sensor wiring 1. EX9-OET1/EX9-OET2/ EX9-OEP1/EX9-OEP2 EX9 Series General Purpose Output Block Part Names 1. EX9-OET1/EX9-OET2/EX9-OEP1/EX9-OEP2 Output wiring EX9-OET1/EX9-OET2/ EX9-OEP1/EX9-OEP2 output connectors Mounting Dimensions when general purpose output block is connected Pin alignment and connection drawing of the Output Cable Power supply wiring EX9-PE1 power supply connector No.0 EX9-PE1 power input connector No.1 Pin alignment and connection drawing of the Power Supply Cable 1. EX9-OET1/EX9-OET2/EX9-OEP1/EX9-OEP2 1. EX9-OET1/EX9-OET2/ EX9-OEP1/EX9-OEP2 Option EtherNet/IP compatible communication Troubleshooting Overall system