Contents | SMC Networks EX500-GEN1 specification

Thank you for purchasing the SMC reduced wiring system EX500 series.

Please read this instruction manual carefully and understand the contents before use so that you can operate this unit safely and correctly.

Please keep this manual handy for future reference.

OPERATOR

This instruction manual has been written for those who have knowledge of machines and equipments that use reduced wiring system as well as the sufficient knowledge to assemble, operate, and maintain such devices.

Before performing assembly, operation and/or maintenance, please read this manual carefully and understand the contents.

To facilitate recycling, this
manual is printed using	This manual is printed in the
biodegradable soy ink, which	"non-water system", which does
can easily be de-inked.	not output toxic liquid waste.

Contents
SAFETY	2
Product Summary	5
EX500
Part Names	6
Dimensions	7
Installation	7
Specification	8
Wiring	11
Display/Switch setting	18
SI Unit
Part Names	21
Dimensions	22
Mounting/Wiring	23
Specification	24
Display	25
Input Unit Manifold
Part Names	26
Dimensions	27
Installation	28
Specification	29
Wiring	30
Display	31
EX9 Series General Purpose Output Block
Part Names	32
Dimensions	33
Mounting	34
Wiring	35
Specification	38
Display	39
Option	40
Troubleshooting	42

Image 2

SMC Networks EX500-GEN1 instruction manual Contents

Contents

Reduced wiring system Contents Otherwise accident caused by malfunction can result Do not operate beyond specification rangeOtherwise injury or failure can result Otherwise injury can result Product Summary SafetySystem configuration general Manifold valve with SI unit SV/VQC series EX500 Part Names Dimensions unit mmInstallation unit mm EX500 body Higher-level bus SpecificationBasic specifications Mapping Wirings is explained in the following order WiringSpecification Lower-level bus Power supply wiring WiringCommunication wiring Cable connection Cable plug Branch wiringSingle power supplies For GW unit Manifold valve Input unit manifold configuration For GW unit Input unit manifold configuration Display Display/Switch SettingSwitch setting SI Unit Part Names Display/Switch SettingDefault settings SI unit for SV series valves EX500-S Mounting and removing methods of SI unit are as shown below Mounting/WiringEX500-Q SI unit for VQC series valve EX500-Q DisplaySI unit for SV series valve EX500-S Applicable valve series When only input blocks for M8 connector are connected Input Unit Manifold Part Names When only input blocks for M12 connector are connected InstallationDimensions unit mm Specifications for Input unit Correspondence between input number and input block Sensor wiringLights off Sensor signal input OFF logical Connect sensors to the sensor Part name Application EX9-PE1EX9-OET1/EX9-OET2 EX9-PE1 Dimensions when general purpose output block is connected Output wiringEX9-OEP1/EX9-OEP2 output connectors Mounting EX9-PE1 power supply connector No.0 EX9-PE1 power input connector No.1 EX9-OET1 EX9-OET2 EX9-OEP1 EX9-OEP2 PWR Option EtherNet/IP compatible communication TroubleshootingOverall system COM a D LED