Sonos Digital Music System manual If you are connecting a ZonePlayer

2-6 Chapter 2: System Setup

Step 2: Place the ZonePlayers in the rooms of your choice

Place the ZonePlayers in the rooms of your choice. If you are setting up a ZonePlayer 100, attach the speakers. If you are setting up a ZonePlayer 80, connect it to an external amplifier.

If you are connecting a ZonePlayer 100

Your speaker’s power rating should be at least 75W for 8 Ohm speakers, and at least

150W for 4 Ohm speakers. Do not connect speakers rated at less than 4 Ohms.

Note: Connect the red (+) and black (-)terminals from each speaker to the corresponding terminals on the ZonePlayer. Mismatching of polarities will result in weak central sound, and a distorted sense of sound direction.

1.When making connections, ensure that none of the strands of your speaker wire come in contact with an adjoining terminal on the rear panel.

2.Use your thumb or finger to firmly push the spring- loaded speaker connector post inward to reveal the connection hole.

3.Insert the stripped end of the speaker wire into the hole, then release. The stripped portion should be caught firmly in the connector post.

4.Repeat to install the other speaker wires.

5.Attach the power cord and plug into a wall outlet.

The Mute button indicator and the ZonePlayer Status indicator will begin to flash. (If this ZonePlayer was previously connected to another Sonos Digital Music System, the ZonePlayer Status indicator may light solid white instead.)

If you are connecting a ZonePlayer 80

Note: If you are replacing the wired ZonePlayer in an existing Sonos Digital Music System with a ZonePlayer 80, first add the new ZonePlayer 80 to your music system. You can then unplug the wired ZonePlayer, replace it with the ZonePlayer 80, and move the original ZonePlayer to a new location.

1.Attach the power cord and plug in the ZonePlayer 80.