Connect the calibration mic to the A.CAL MIC jack on tile front panel, and set it up at the ear level using a tripod, etc. (not supplied). The t>ont of each speaker should face the calibration mic. and there should be no obstruction between tile speakers and the calibration mic. Be quiet during tile measurement.

Calibration rnic

5 Press 4,/4, to select [YES], then press

®.

Culibration sturts.

m

Avoid being in the measurement area and making noise during the measurement (about one minute), to avoid measurement faihlre. During the measurement, test signals are output from the speakers.

The environment of the room in which the system is installed may all_.ct measurements.

If an error message appears, R)llow the message, then select [YES].

All error message appears when: the headphones are connected.

the calibration mic is not connected.

front speakers are not correctly connected.

surround speakers arc not correctly connected.

front and surround speakers are not correctly connected.

subwoofer is not connected.

Press <-/4,/4,/+ to select [YES] or [NO], then press @.

The measurement is OK.

Disconnect

the calihration mic. then select

D.

 

 

<

[YES]. The result is implemented.

o tD

D.

¢0

 

D.

The measurement is not OK.

e-

3

Follow the message, then select [YES] to

retry.

ID

 

You can check the distance between the listening position and each speaker. See page 92.

continued_

85us

Page 85
Image 85
Sony DA V-HDX5OO operating instructions 85us, Press 4,/4, to select YES, then press, Measurement is not OK