Set the SLATE switch to either MIC or 1 kHz.
Set the FUNCTION switch to
SLATE.
Location and Function of Parts and Controls
When M-S is selected on the 5. CH LINK/M-S sub-menu; The unit is in M-S mode.

Select this position for M-S decoding when an M-S microphone is used.

Connect channel 1 and channel 3 to the M side and channel 2 and channel 4 to the S side. In such a case, the input level control of the CH-1 and CH-3 act as an input level control and the input level controls of the CH-2 and CH-4 act as a phase control. Turning the phase control to the right provides an expansive feeling.

When the switch is set to OFF: Controls and switches act as those of each channel, independently.

2 Digital function section

1 LIGHT switch

2 SLATE switch

3 LCD

6 Slate microphone

5 ADJUST knob

4 FUNCTION switch

1 LIGHT switch

Turns the light of the LCD on or off.

2 SLATE switch Only activates when the

4 FUNCTION switch is set to SLATE. Turns the slate function on or off. The slate function allows you to record the scene number or take number along with the sound at the beginning of a recording for each cut, or adjust the level using a 1-kHz reference signal when recording using a camcorder or recorder.

MIC: Outputs the sound to all of output connectors from the built-in condenser microphone.

1 kHz: Outputs a 1-kHz reference signal to all of the output connectors.

OFF: The slate function is disabled.

To output the voice from the microphone or a 1-kHz reference signal

1 Turn the L/R MASTER volume control toward the right to increase the volume.

2

3

4 Push the ADJUST knob. Output of the voice from the microphone or a 1 kHz. reference signal depends on how you press the ADJUST knob.

When you press and hold the ADJUST knob:

The sound or signal is output while this knob is being pressed when you release the knob, output ceases.

10