Location and Function of Parts and Controls

Notes

•Be sure not to connect devices other than a UHF portable tuner.

•The unit outputs the power, only when the unit operates with an external power supply.

This connector outputs the power by dividing the power input via the DC IN 10-15 V connector. Thus the output voltage depends on the power input via the DC IN 10 - 15 V connector.

5 CASCADE IN (Cascade signal input) connector (Phono jack) Used for a cascade connection. When this unit is as the second one connected, connect this connector to the COAXIAL connector located on the right panel of the first DMX-P01. This unit is synchronized with the first DMX-P01 using the master clock signal extracted from the signal of this connector.

Note

3 INPUT (analog signal input) connectors (XLR type 3-pin, female) Input the analog audio signals of the four channels CH1, CH2, CH3 and CH4.

4 LINE/MIC/MIC +48V switch Selects the position to match the incoming signal level of each channel. LINE: Set to this position when

connecting equipment with an input signal level between +10 dBu and –30 dBu.

MIC: Set to this position when connecting the equipment with an input signal between –30 dBu and –70 dBu, especially when connecting a microphone.

MIC +48V: Set to this position when connecting the equipment with an input signal between –30 dBu and –70 dBu, especially when connecting a DC +48V power microphone.

In a cascade connection, the sampling rate of both DMX-P01 mixers must be matched. Set the sampling rate to match using the SAMPLING RATE switch.

Also, do not input the IEC60958 format signal to the CASCADE INPUT connector.

14